Profiled sheeting H-114 standard lines

Automatic roll decoiler - RS-7M-1500 (Driven, cantilevered)

Type - Cantilever with attachable support, with manual blades spreading tool

Weight - 10350 kg
Load capacity - 7000 kg
The decoiler blades spreading mode - Manual by the screw drive
Spreading stroke limit - 480-610 mm
Decoiler drive type - Asynchronous, frequency-controlled by Vesper inverter
Decoiler drive power - 7.5 kW
Metal decoiling speed - 50 m/min
Width of the coil (blanks) - 1500 mm
Coil inner diameter - 480-600 mm
Coil outer diameter - 1500 mm
Operating mode - automatic
Loop Tracking - Extension Rod
Emergency sensor for disconnecting the line when the loop is pulled - Limit switch
Overall dimensions (LxBxH) - 2300x1160x1700 mm
Possibility of reverse rotation - provided
The number of the decoiler trunk blades - 3

COLD ROLL-FORMING MILL H-75

Coil loading mode - manual
Operation area width - 1400 mm
Metal thickness processed - 0.7-1.0 mm
Guide table - adjustable, with three idle input rolls
Productivity - 15 m./min
Drive type - Asynchronous, frequency-controlled
Installed power of the motor gear – 44 kW
Drive rolls position - all bottom
Roll drive type – chain
Roll diameter - 110 mm
Profile length accuracy - ± 1-2 mm
Number of stands – 35 pcs
Band motion sensor - circular pulse encoder "LIR"
Control type - programmable controller
Forming rollers material - Steel 40H GOST 4543-2016 with heat-treatment
Overall dimensions (LxBxH) - 43800х1950х1950 mm
Weight - 68 000 kg
Rope-Stop, with Stop button – Emergency type
Guillotine unit type - profile electromechanical
Installed power – over 7.5 kW
Material of guillotine blades - ChVG, Ch12М Hardening 57…60 HRC

ACS (automated control system)

Operating modes
Manual - Operation of actuators by pressing buttons
Semi-automatic - Operation of the guillotine drive by pressing a button, the rest in automatic mode
Automatic - Operation of actuators according to the controller program
Material change mode - Line stop and metal cut for waste-free material change
Emergency mode - Line stop without resetting the program in case of failure or malfunction of the decoiler, sheet piler or guillotine

Total counter of all rolled metal
Finished sheets cut-off accuracy - ±1-2 mm
Number of programmable positions (quantity by length) - 16 pcs
Control panel - Touch 10", multifunctional "Delta Electronics"
Electrical cabinet - RITTAL
Controller and frequency drives - «Delta Electronics»

Quest archive - unlimited
Distribution of production tasks from the manufacture central server of the enterprise
Remote diagnostic system
Completion of ACS with advanced features for working in the BORA-OPTIMA software envelope

Automatic Finished Sheet Piler

Sheet Piler Control System – Programmable Controller
Pick-up feeder drive "SITI" - 2.2 kW
Operating mode - Automatic
Manual - push-button
Sensors for tracking the position of the pick-up feeder - Non-contact inductive
Sheet piler length - 6 r.m.
Receiving carts - Roll-out of the cart to the side (forward along the rolling direction)