K-2P line

Automatic roll decoiler - RS-7M
(Driven, cantilevered)

Type - Cantilever with attachable support, with manual blades spreading tool
Weight - 1050 kg
Load capacity - 7000 kg
The decoiler blades spreading mode - Manual by the screw drive
Spreading stroke limit - 480-610 mm
Decoiler drive type - Asynchronous, frequency-controlled by Vesper inverter
Decoiler drive power - 7.5 kW
Metal decoiling speed - 50 m/min
Width of the unwound roll (blanks) - 1250+7 mm
Roll inner diameter - 480-600 mm
Coil outer diameter - 1500 mm
Operating mode - automatic
Loop Tracking - Extension Rod
Emergency sensor for disconnecting the line when the loop is pulled - Limit switch
Overall dimensions (LxBxH) - 2300x1160x1700 mm
Possibility of reverse rotation - provided
The number of the decoiler trunk blades - 3

Cross-cutting Machine K-2P

Working area width - 1250±10 mm
Guide table - adjustable, with three non-powered input rolls
Cutting speed - 20 m/min
Drive type - asynchronous, frequency-controlled
The installed power of the driving motor gear of the SITI guillotine is 2.2 kW
Installed power of the driving motor gear - 2.2 kW
Length cutting accuracy (per 3000 mm) mm ± 1
Band motion sensor - circular pulse encoder "LIR"
Control - programmable controller
Overall dimensions - 6200x1680x1750 mm
Weight - 1800 kg
Emergency Rope-Stop, with Stop button
Push-button station for loading modes of operation on the guide table – 1 pc

Automatic Finished Sheet Piler

Sheet piler Control System – Programmable Controller
Pick-up feeder drive "SITI" - 0.75 kW
Operating mode - Automatic
Manual - push-button
Sensors for tracking the position of the pick-up feeder - Non-contact inductive
Sheet piler length - 3 l.m.
Receiving cart - 3 l.m.

ACS (automated control system)

Quest archive - unlimited

Operating modes
Manual - Operation of actuators by pressing buttons
Semi-automatic - operation of the guillotine drive by pressing a button, the rest in automatic mode
Automatic - operation of actuators according to the controller program
Material change mode – line stop and metal cut for waste-free material change
Emergency mode – line stop without resetting the program in case of failure or malfunction of the decoiler, sheet piler or guillotine

Total counter of all processed metal

Number of programmable positions (quantity by length) - 16 pcs

Control panel - Touch 10", multifunctional "DeltaElectronics"

Electrical cabinet - RITTAL

Controller and frequency drives - "DeltaElectronics"