Cantilevered decoiler RS-1.5

Type - (driven, cantilevered)
Weight - 300 kg
Load capacity - 1.5 t
Decoiler drive power - 2.2 kW
Decoiler drive type - Asynchronous, frequency-controlled by Vesper inverter
Coil inner diameter - 450-600 mm
Decoiler blades spreading mode - Manual by the screw drive
Max. coil width - 450 mm
External diameter of the coil processed - 1500 mm
Decoil speed synchronization - By slack loop, via control bar
Emergency sensor for disconnecting the line when the loop is pulled - Limit switch
Reverse mode - provided
Number of decoiler trunk blades - 4 pcs
Dimensions - 1200x800x1450 mm

"BARRERA" mill

Productivity - 25 r.m./min
Number of stands - 10 pcs
The processed metal thickness - 0,4-0,6mm
Working area width - 156±2 mm
Mill drive - asynchronous, frequency-controlled "Delta Electronics"
Drive rolls position - all bottom,
Roll drive type - chain
Roll diameter - 65mm
On-center spacing of the rollers (change-over for a different metal thickness) is changed using the adjusting screws installed on each support
Installed power: 5 kW
Dimensions: 1300mm x 1000mm x 3700mm
Guillotine electromechanical profile
Guillotine at the rolling mill output with 3-D cut (type to be specified by the customer)
Cutter material - ChVG, Ch12 M GOST 5950-2000
Trip sensor - Inductive non-contact
Operation control - By programmable controller

ACS (Automated control system)

Operating modes

Manual - Operation of drives by pressing buttons
Semi-automatic - Operation of the guillotine drive by pressing a button, the rest in automatic mode
Automatic - Operation of drives according to the controller program
Material change mode - Line and cut-off stop for waste-free material change
Emergency mode - Line stop without resetting the program in case of failure or malfunction of the decoiler, stacker, guillotine

Finished panels cut-off accuracy - ±1-2 mm
Number of programmable positions (quantity by length) - 16
Control panel - Touch 7", multifunctional "Delta Electronics"